Tissot Sea Touch Spanner Sign after Battery Change
Posted: Fri Oct 12, 2018 11:07 pm
Removing the Spanner Sign after Battery Change
1. Put the watch into sleep mode as per the manual.
(Activate touch screen, touch centre till OPT appears, middle button once and the shows 24h or 12h, touch centre twice to show SLEEP then leave a few seconds and LCD goes blank and both hands go to the 12 o'clock position)
2. Once in sleep mode hold the 2 o'clock position button for 6 seconds then touch the 6 o'clock or Dive position on the face of the watch.
3. The digital display should show something like 06G316, if not then repeat step 2.
4. Then use 2 o'clock position button to cycle through all the different message codes until you are back at the first one.
5. Finally use the 3 o'clock position button to come out of sleep mode.
1. Put the watch into sleep mode as per the manual.
(Activate touch screen, touch centre till OPT appears, middle button once and the shows 24h or 12h, touch centre twice to show SLEEP then leave a few seconds and LCD goes blank and both hands go to the 12 o'clock position)
2. Once in sleep mode hold the 2 o'clock position button for 6 seconds then touch the 6 o'clock or Dive position on the face of the watch.
3. The digital display should show something like 06G316, if not then repeat step 2.
4. Then use 2 o'clock position button to cycle through all the different message codes until you are back at the first one.
5. Finally use the 3 o'clock position button to come out of sleep mode.
- seatouch.jpg (65.19 KiB) Viewed 6094 times